Skip to main content
Running Feet: rft

What is running feet in construction and interiors?

Running feet, written rft or Rft, is a length measured along a run, such as a kitchen counter, a skirting line or a railing, regardless of its width or height. The height or depth is fixed in the item description, so one rate covers each foot of the run. Running metre (rmt) is the metric equivalent.

Key facts

Abbreviation
rft or Rft; metric equivalent rmt
Conversion
1 running metre = 3.28084 running feet; 1 ft = 0.3048 m exactly
Used for
Kitchen units, wardrobes, skirting, railings, cornices, coves, pipes
Must state
The fixed height, depth or section the rate assumes

How do you calculate running feet?

Measure the length of the run along its line in feet, add the separate runs, and write down the depth or height the rate assumes. Width and height are not multiplied in.

Worked examples:

ItemWorkingRunning feet
Straight kitchen base run of 3.6 m3.6 × 3.2808411.81 rft
Skirting in a 4.0 m × 3.5 m room with a 0.9 m door(15.0 − 0.9) × 3.2808446.26 rft
L-shaped counter, 10 ft and 7 ft runs measured along the walls10 + 717 rft

For the L-shaped counter, a 2 ft deep corner sits in both runs. Measured along the front edge instead, the counter is 10 + 7 − 2 = 15 rft. Agree which way the vendor measures before comparing quotes.

Running feet vs square feet

Running feet measures length only; square feet measures area. A running-foot rate assumes a fixed height or depth, while a square-foot rate is paid on length times height.

A wardrobe can be quoted either way: per sq ft of front area or per running foot at a stated height and depth. The same wardrobe gives different numbers, so convert both quotes to one basis before comparing. Our interior BOQ format lists which unit suits each item.

Where is running feet used in interior work?

Mostly for modular kitchen base and wall units, wardrobes quoted by run, countertops of fixed width, skirting, and false ceiling coves and borders.

Ask the vendor to state what one running foot includes: carcass depth and height, shutters, back panel, shelves, hardware and installation. Base and wall units should be separate lines because their depth and height differ. Skirting needs its height and material in the description.

How do you convert running feet to running metres or sq ft?

Divide running feet by 3.28084 to get running metres. To get an area, multiply the length by the fixed height or depth in the same unit.

ConversionWorkingResult
46.26 rft to running metres46.26 ÷ 3.2808414.10 rmt
14.1 m of 100 mm skirting to m²14.1 × 0.101.41 m²
1.41 m² to sq ft1.41 × 10.763915.18 sq ft

Use area only when the rate is per area. A per-rft rate and a per-sq-ft rate for the same item are not comparable until both are on one basis.

Common mistakes with running feet

The usual mistakes are applying a per-rft rate to a quantity in running metres, counting corners twice, and comparing quotes that assume different depths or heights.

  • Unit mismatch. Never apply a per-rft rate to an rmt quantity; convert first.
  • Corners. State whether corner units are counted in one run or both.
  • Hidden scope. A low rate per rft may leave out shutters or hardware.
  • Area-based guesses. Running lengths come from the layout, not from built-up area.

Go deeper

Related terms

Sources

Checked 2026-11-03. Contract documents, tender conditions and the structural drawings for your project take precedence over the general rules on this page.

All construction terms in the glossary